I see a lot of this also...

Posted By: NMMT on 2009-08-21
In Reply to: Anybody else been through this? - Staying Anonymous

and I strive for quality over quantity any day. I would be embarrassed to make so many mistakes, not to mention the fact it may cause potential harm to the patient. I have been turned down for job opportunities and then read a post from a fellow MT that may read...I finely found a new job!! I start tomorow at a locle hospitle. Mom would be soooo prowd!! ;-)

Complete Discussion Below:

marks the location of current message within thread

Anybody else been through this? - Staying Anonymous
- Almighty computer matters - not MT or quality - starting VR this week
- Your post could have been written by me - Backwards typist
- good argument for doing away with - deenibeeni
  - I AGREE COMPLETELY! I'd rather be paid a consistent, respectable hourly rate - for MT'ing. I think the time has come. nm
    - Hourly pay is nice... - MT
      - hourly turning out to be not so great. - Mary
  - My thoughts... - MT
    - I would always hope that a responsible intelligent MT... - ndmt
      - Some good points... - MT
        Who is to say that the MTs turning out these reports... - ndmt
        Whose fault is poor quality? - Alice
        Well, we'll have to disagree... - MT
        I agree with you 100% - Amen
        No guilty conscience...no martyr syndrome, either. - ndmt
        If MTs were doing their job... - MT
        So what about the poster above being instructed by the MTSO, - ndmt
  - clarification - "this" - deenibeeni
- had a similar experience - Stillmting
- I'm with you Cranky/Fingers - Also anon
- I have far too much pride in my work - CrankyBeach
  - Talk about old school... Started out in - linda
- What I did... - Fingers
- I may be the turtle of the bunch, - I'm with you on this one!
- In the past I always opted for a slightly lower - sm
  - Hit the nail on the head! - mtme
  - if that is the case, then we cannot complain when - sm
    - I think it is the fact that the client is already paying less... - ndmt
      - Which is why I don't care if a few mistakes slip by. - The client sure doesn't - too busy pinching pen
  - Point well taken... :-) - NMMT
- I see a lot of this also... - NMMT
  - I think the fact that there was a wink - It was a joke.
- Yes I have - Also anon

The messages you are viewing are archived/old.
To view latest messages and participate in discussions, select the boards given in left menu

Other related messages found in our database